FGR-Series Ethernet

900 MHz Spread Spectrum Wireless Radios
  The FGR-115RE is a long range, very robust Ethernet bridge. It is ideal for applications where an Ethernet interface is required, but an average throughput in the 100 Kbps range is sufficient. When using radio for data communications, there is always a tradeoff between throughput and range. This product provides both a long range and a significant data rate. For example, SCADA applications may need a long-range link, but they rarely need throughput above 100 Kbps.
 
Common features of the FGR series:

The FGR family is the latest improvement in our line of products, with features including:

• New Separate diagnostic port - real time remote diagnostics and setup, transparent to network communications.
• New Improved diagnostics - including RSSI levels in dBm, antenna VSWR and transmit current.
• New Wide input voltage range - 6 to 30 Volt DC.
• New The lowest current draw of any radio - at 12 Volts:
  • < 5 mA in sleep mode with no wake up delay
  • < 16 mA in idle mode
  • < 60 mA in full time receive
  • < 500 mA transmit current
• New Improved low signal performance - RISC-based signal demodulation with matched filter.
• New Synthesized waveform transmit data - reduces out of band modulation products.
• High Noise Immunity - Superior Performance in noise congested environments.
• Secure - Proprietary spread spectrum technology prevents detection and unauthorized access.
• High Speed - 115.2 Kbps continuous throughput.
• Long Range - 60+ mile line of sight range.
• Error Free Communications - 32 bit CRC with automatic retransmission.
• Industrial Grade Specifications - 100% tested for full performance from -40 °C - +75 °C.

• Ruggedized enclosure
• Ethernet 10baseT interface
• Available in rugged or OEM board-level module
• 153 Kbps rate over the radio link
• RS232/485 interface version: OEM board-level module or rugged or waterproof enclosure.

Ordering Info
Model	Interface	Enclosure	Rear panel
FGR-115RE	Ethernet	Rugged